Silverado Won't Move In Drive - You should see the cable rotate the shifter. If it ran good, you parked it, it got f'in cold and now it doesn't. If a truck will only move in reverse, the transmission controller may be faulty, the fluids might be low, the fluid tubes are cracked/broken, or the speed sensor is not working. Turned out the be low fluid level in the trans, this was caused by the seal between the trans and transfercase leaked. It would force the fluid from the trans into the transfercase,. The next time i went to use the truck, it won't move in any gear (r, d, 1st). There is a message that reads service 4 wheel drive. My truck has the dial selector switch for 2 hi, 4. I put the transfer case (246gm) in auto 4wd and was able to drive enough to pull off the highway. I tested it a few more times and in 2wd there is nothing, not engaging. When a silverado wonโt move in drive, itโs important to first identify the cause of the problem. Common causes include low or contaminated transmission fluid, faulty torque converter, faulty. Level I Antiterrorism Awareness Training Pretest Answerspittube Detail
You should see the cable rotate the shifter. If it ran good, you parked it, it got f'in cold and now it doesn't. If a truck will only move in reverse, the transmission controller may be faulty, the fluids might be low, the fluid tubes are cracked/broken, or the speed sensor is not working. Turned out the be low fluid level in the trans, this was caused by the seal between the trans and transfercase leaked. It would force the fluid from the trans into the transfercase,. The next time i went to use the truck, it won't move in any gear (r, d, 1st). There is a message that reads service 4 wheel drive. My truck has the dial selector switch for 2 hi, 4. I put the transfer case (246gm) in auto 4wd and was able to drive enough to pull off the highway. I tested it a few more times and in 2wd there is nothing, not engaging. When a silverado wonโt move in drive, itโs important to first identify the cause of the problem. Common causes include low or contaminated transmission fluid, faulty torque converter, faulty.